GE
New Member
Posts โข 176
Likes โข 96
September 2017
|
Creating stencils, by GE on Jan 27, 2018 23:36:25 GMT 1, Quick question.
Does anyone use anything like a graphtec to create stencils?
Just wondering if there is a specific media I could run through it for optimum finish
I have had a bit of a play about with my machine to see if it can be done, after a few trial runs some are looking ok but not the best.
Quick question.
Does anyone use anything like a graphtec to create stencils?
Just wondering if there is a specific media I could run through it for optimum finish
I have had a bit of a play about with my machine to see if it can be done, after a few trial runs some are looking ok but not the best.
|
|
Opie
Artist
New Member
Posts โข 391
Likes โข 1,132
September 2012
|
Creating stencils, by Opie on Jan 28, 2018 1:54:57 GMT 1, Hand cut all the way 
Hand cut all the way |
|
iamzero
Full Member
Posts โข 9,190
Likes โข 8,542
May 2011
|
Creating stencils, by iamzero on Jan 28, 2018 8:44:25 GMT 1, I have no idea why someone would want to get a machine to cut the stencil. Soul less.
I have no idea why someone would want to get a machine to cut the stencil. Soul less.
|
|
Dive Jedi
Junior Member
Posts โข 6,160
Likes โข 9,391
October 2015
|
Creating stencils, by Dive Jedi on Jan 28, 2018 10:02:10 GMT 1, I have no idea why someone would want to get a machine to cut the stencil. Soul less.
Personally I prefer not to use software to create the stencils. I wouldn't know how anyway.
Using Illustrator or similar software basicly creates the same look every time - for everyone.....
If you use software to draw layers and a machine to cut the stencils
you might as well get a robot to spray it as well.
I have no idea why someone would want to get a machine to cut the stencil. Soul less. I think he means drawing the stencils rather then cutting them. Personally I prefer not to use software to create the stencils. I wouldn't know how anyway. Using Illustrator or similar software basicly creates the same look every time - for everyone..... If you use software to draw layers and a machine to cut the stencils you might as well get a robot to spray it as well. |
|
GE
New Member
Posts โข 176
Likes โข 96
September 2017
|
Creating stencils, by GE on Jan 28, 2018 10:22:32 GMT 1, To be honest I have used the machine to draw mostly but also cut at times.
What should I be using to create my stencil out of?
Thanks
To be honest I have used the machine to draw mostly but also cut at times.
What should I be using to create my stencil out of?
Thanks
|
|
