minibear
New Member
🗨️ 872
👍🏻 728
March 2013
|
Avoiding Warp Prints, by minibear on Feb 18, 2014 12:20:33 GMT 1, Hey guys,
I've just seen, and unfortunately missed out on the Eine Change deal that went down on the boards, and the OP mentioned the print being warped. I'd be interested to know from y'all experiences, when does warping occur, and is it a result of not allowing to flatten sufficiently etc?
Am in the process of flattening a few prints and would be good to know incase I do something that could have long term ramifications. What's your flattening advice?
Hey guys,
I've just seen, and unfortunately missed out on the Eine Change deal that went down on the boards, and the OP mentioned the print being warped. I'd be interested to know from y'all experiences, when does warping occur, and is it a result of not allowing to flatten sufficiently etc?
Am in the process of flattening a few prints and would be good to know incase I do something that could have long term ramifications. What's your flattening advice?
|
|
iamzero
Full Member
🗨️ 9,190
👍🏻 8,545
May 2011
|
Avoiding Warp Prints, by iamzero on Feb 18, 2014 15:44:00 GMT 1, Cockling of the paper is usually down to humidity and placement of the artwork but also incorrect framing where the paper is not allowed to move sufficiently within the mount when it's needed.
Cockling of the paper is usually down to humidity and placement of the artwork but also incorrect framing where the paper is not allowed to move sufficiently within the mount when it's needed.
|
|