robalb
New Member
๐จ๏ธ 59
๐๐ป 41
May 2014
|
High Up - Framed, by robalb on Aug 9, 2018 17:13:53 GMT 1, I have just framed High Up.
This is a budget frame with non reflective acrylic glass made by a โweb onlyโ based company. The mount colour is referred to as cinder (brown).
I think it works well, though I will swap out the glass soon since iโm not a fan of the acrylic which appears to have a matt finish and is not very clear! In part, I cut corners to get the print out itโs tube and keep flat.
I have just framed High Up. This is a budget frame with non reflective acrylic glass made by a โweb onlyโ based company. The mount colour is referred to as cinder (brown). I think it works well, though I will swap out the glass soon since iโm not a fan of the acrylic which appears to have a matt finish and is not very clear! In part, I cut corners to get the print out itโs tube and keep flat. |
|
Majestic
Junior Member
๐จ๏ธ 1,042
๐๐ป 1,462
January 2016
|
High Up - Framed, by Majestic on Oct 12, 2018 12:30:56 GMT 1, Good job - sets the print off nicely.
Good job - sets the print off nicely.
|
|
Deleted
๐จ๏ธ 0
๐๐ป
January 1970
|
High Up - Framed, by Deleted on Oct 12, 2018 18:27:35 GMT 1, Nice job Robalb; would you recommend the web-based framers?
Think most of have prints but are put off framing them all due to costs so please let us know your experience - good and bad..
Nice job Robalb; would you recommend the web-based framers?
Think most of have prints but are put off framing them all due to costs so please let us know your experience - good and bad..
|
|
robalb
New Member
๐จ๏ธ 59
๐๐ป 41
May 2014
|
High Up - Framed, by robalb on Oct 19, 2018 19:59:51 GMT 1, I had a good experience with the online framers.
The site I used asked for the print dimensions and then cut the mount so it overlapped the print by 3mm or so on all sides. You can even upload a photo of your print to their website and it will position it in the frame and mount of your choice to give an impression how it will look.
With regards to the frame the mitre joints were actually better than my local framers!
I have since deleted the email but I think I used frames.co.uk
I would deffinately use again.
I had a good experience with the online framers.
The site I used asked for the print dimensions and then cut the mount so it overlapped the print by 3mm or so on all sides. You can even upload a photo of your print to their website and it will position it in the frame and mount of your choice to give an impression how it will look.
With regards to the frame the mitre joints were actually better than my local framers!
I have since deleted the email but I think I used frames.co.uk
I would deffinately use again.
|
|
